Busy Weekend

OK done, the Parlour is now caught up to the Tenor, so I can put away all the body jigs & moulds and get on with making necks..

This weekend I  carve to top braces and finished voicing the top, glued on the back & top, cut the binding channels and the channel for the top Abalone purfling and got all the bindings & purfling installed.. I was a bit concerned how the Wenge would route as it seem brittle but it was fine..

Still lots of finish sanding to do on both bodies but that can wait until later...

All in all a productive weekend and I'm officially in love with my new binding router jig.. works so darn well..

I'm also really happy with how the binding came out on the Parlour the Abalone looks great and not too gaudy..

Very happy with this look

No Abalone on the back

End wedge

Top view

Both now waiting for necks

Binding Channels

Undoubtedly one of the more stressful parts of building a guitar taking a 10,000 RPM router to a guitar body, quite a bit can go wrong.. If you've followed this blog you've seen a couple of ways I've cut binding channels in the past.. All worked with varying degrees of stress and some variance in accuracy.. Most of the jigs I used were chosen to accommodate having a very small space for a shop. I just don't have room for a large parallel arm fleishman/williams-style jig.. I've been looking at the LMI or the Stewmac jig for some time and when LMI updated their design I did some thinking and decided that looked the best..

It is still a compact jig that I can store away in a cupboard when not in use and it works like a charm..

Setup is easy, adjustment straight forward and it works, despite screwing up the install of the top bindings and having to cut them off (with the jig) and even that when well..

Just pay attention to the getting the guitar level in the carrier.

I am far less stressed about cutting binding channels now that I have this jig.

The only change I had to make was a slightly different assembly of the carrier since I am doing a small bodied guitar..

Carrier assembled in a "non-standard" way

The results

Mounted to my work table

Routing Binding Channels

Well today I put the new binding cutter jig I made to the test and it worked quite well, much better than other methods I have tried. I'm very pleased with it :-)

OK Yes I have to add dust collection..

Pretty easy to set up just loosen the two screws for binding thickness adjustment and the built in router depth adjustment for the depth

Looks good