Binding Channels

Undoubtedly one of the more stressful parts of building a guitar taking a 10,000 RPM router to a guitar body, quite a bit can go wrong.. If you've followed this blog you've seen a couple of ways I've cut binding channels in the past.. All worked with varying degrees of stress and some variance in accuracy.. Most of the jigs I used were chosen to accommodate having a very small space for a shop. I just don't have room for a large parallel arm fleishman/williams-style jig.. I've been looking at the LMI or the Stewmac jig for some time and when LMI updated their design I did some thinking and decided that looked the best..

It is still a compact jig that I can store away in a cupboard when not in use and it works like a charm..

Setup is easy, adjustment straight forward and it works, despite screwing up the install of the top bindings and having to cut them off (with the jig) and even that when well..

Just pay attention to the getting the guitar level in the carrier.

I am far less stressed about cutting binding channels now that I have this jig.

The only change I had to make was a slightly different assembly of the carrier since I am doing a small bodied guitar..

Carrier assembled in a "non-standard" way

The results

Mounted to my work table